Tundra Remote Door Lock Reprogram

The locks should cycle once to verify that the car has accepted your remote.

Tundra remote door lock reprogram.

Using the door control pad located on the driver s side door press the lock and unlock buttons once again for five passes. Turn the ignition to on and then back to off and remove the key from the ignition. Close the driver s door. While there is the possibility of a pretty big electrical issue most of the problems are minor and easy to fix.

Press the lock button by itself and hold for 2 seconds. Luckily the toyota tundra power door locks are pretty easy to self diagnose what s wrong. If not start again at step 1. If you have done everything correctly within three seconds the door locks should lock then unlock automatically.

Each set represents one pass. System should now lock and unlock vehicle once to confirm registration twice to indicate registration has failed. Press and release lock or unlock button. Within 3 seconds the door locks should lock and then unlock once indicating successful programming.

If you key fob no longer unlocks the doors it is time for a new battery. This is the best and easiest fix. Repeat steps a and b in step 6 for each new remote. Insert your key into the ignition switch and put it in the run position.

If the door locks cycle twice repeat steps a and b in step 6 as the remote was not accepted. You must complete these operations within 40 seconds. Once your car is in programming mode with the remote you are trying to program press the unlock and lock buttons simultaneously for about 2 seconds then release and press just the lock button for 1 second.